The Honda Goldwing has headlights and turn signal lights. These lights are of important significance for operating your Honda Goldwing safely. Driving your Goldwing with faulty lights can result in an accident. In lots of states, you could also be fined for driving with a defective light. It is due to this fact very important that you always be sure that your lights are operating correctly before driving your Goldwing. Replacing any light on a Goldwing is an easy process that should not take greater than 15 minutes.
Honda Goldwing Lights Installation Instructions
1. Flip the Goldwing’s engine off and put on the gloves.
2. Take away the mirror trim on either side by pulling it off. You could need to make use of a slotted screwdriver if the mirror trim is stuck. As soon as the mirror trim is eliminated, you will be able to see the securing screw on the facet of the headlight assembly. Remove both securing screws with a Phillips screwdriver.
3. Take away the screw holding the left turn signal and take away the flip sign from the Goldwing. Make sure to disconnect the electrical-wire connector on the rear of the turn signal meeting earlier than removing it from the vehicle. Repeat this step with the right-hand flip signal.
4. Remove the decrease trim screws on each side of the lower trim. Take away the lower trim to disclose the two decrease mounting bolts. Remove the 4 bolts securing the headlight assembly to the Goldwing. Disconnect the electrical-wire connector and pull the assembly out.
5. Take away the two rubber seals on the rear of the assembly. The top rubber seal incorporates the high-beam bulb and the underside rubber seal incorporates the low-beam bulb. Disengage the spring clips and take away the bulb sockets.
6. Pull the previous bulbs out of their sockets and install new bulbs in their place. The low-beams use H7 bulbs and the excessive-beams use H3 bulbs. Place the sockets back into the meeting, reattach the spring clips, and place the rubber seals back onto the assembly. Reconnect the electrical-wire connector to the assembly and place it again into the Goldwing.
7. Reattach the 4 mounting bolts. Place the lower trim again into place beneath the headlight assembly and reinstall its two screws.
8. Remove the seal behind every turn signal assembly. Disengage the spring clip and pull the socket out of each assembly. Pull the bulb out of the socket and install a substitute 1156-kind bulb. Reinstall the sockets into the assemblies, reattach the spring clips, and reattach the rubber seals. Place the turn signal assemblies again into the Goldwing and safe them by reinstalling their securing screws.
9. Reinstall the 2 side screws to safe the headlight meeting to the Goldwing and reattach the mirror trim.
